General Manufacturing

PBUS-25-Hammond-RackCabinet-400.jpg
| | | | |

Hammond Manufacturing: Swing-Out Sectional Floor/ Wall Mount Rack Cabinet

Hammond Manufacturing’s Swing-Out Sectional Floor/ Wall Mount Rack Cabinet HWF Series with 500lb capacity is available in 3 heights. Each one features optional doors that install in minutes and are available in vented, tinted window and solid. The top of the rear section includes a 3U cutout for optional rack mount fans or accessory mounting, and the main body can be installed to swing from left-to-right or right-to-left. Includes locking twist-latches.

 

 

 

PBUS-25-Automation-SaginawEnclosures-400.jpg
| | | |

Saginaw Enclosures from AutomationDirect

Saginaw has been serving the electrical industry since 1963, specializing in manufacturing top-quality carbon steel, galvanized steel, and stainless steel electrical enclosures built to accurate dimensions. AutomationDirect is proud to add Saginaw’s standard stock of enclosures, including freestanding, floor-mount, wall-mount, disconnect, modular, operator system, pushbutton, junction box, and wire trough enclosures, to our already extensive line of quality enclosures.

 

 

 

PBUS-25-Bristol-338SeriesMeter-400.jpg
| | | |

Bristol Instruments: 338 Series Optical Wavelength Meter

The 338 Series Optical Wavelength Meter from Bristol Instruments combines speed and affordability to address the most important requirements of optical transceiver manufacturers. The model 338 has a high measurement rate of 25 Hz that results in reduced testing times and greater production throughput. And, its affordable price point, along with a five-year warranty, provides the lowest cost of ownership compared with similar systems.

 

 

 

PBUS-25-RAFI-RAFIX22FSR-400.jpg
| | |

RAFI: RAFIX 22 FSR – Rugged Signal Lamp With Stainless Steel Collar and Red/Green LED

RAFI is expanding its rugged RAFIX 22 FSR control component range with a signal lamp featuring a stainless steel collar with IP65, IP67 and IP69 degree of protection to the front side. The integrated red/green LED can indicate three signal statuses. The translucent indicator is a neutral white in standby mode, green indicates regular operating condition, and red signals faults.

 

 

 

PBUS-25-Cembre-4mmPushInMarkers-400.jpg
| | | | |

Cembre: Precut 4mm Push in Markers, for PMF Holders

SerieFLAT MG-TPMF tags are used for marking cables, conduit, tubes, conductors and components. Presented in stem format, tags are simply snapped off their stems and inserted into the appropriate holders. Consult Cembre for other colours. Compliance is checked by inspection and by rubbing the marking by hand for 15 s with a piece of cloth soaked with water and again for 15 s with a piece of cloth soaked with hexane.

 

 

 

PBUS-25-Wohner-MOTUSC14MotorStarters2-400.jpg
| | | |

Wöhner Presents Groundbreaking Motor Starters MOTUS C14 Based on C14-Technology

With the motor starters of the MOTUS C14 series from Wöhner, short circuits become less scary. If an error occurs, the electronics switch off the motor within a maximum of 10 microseconds. This means that the MOTUS C14 reacts faster than any fuse and this with a low I2t value. By comparison, the reaction time of a conventional fuse-link is about 2,000 microseconds. With a circuit breaker, the switch-off time in case of a fault is even 5,000 microseconds.

 

 

 

PBUS-25-Pepperl-IUT-F190-B40UHF-400.jpg
| | |

IUT-F190-B40 UHF Read/Write Head with Integrated Industrial Ethernet Interface and REST API Expands the Pepperl+Fuchs RFID Portfolio

Pepperl+Fuchs is expanding its comprehensive portfolio of identification solutions with the introduction of the IUT-F190-B40 UHF RFID read/write head, which offers an integrated industrial Ethernet interface and REST API. Using these interface technologies, the IUT-F190-B40, which is designed for medium detection ranges, can be quickly and easily integrated into OT and IT systems.

 

 

 

PBUS-25-Balluff-ETHERCAT-400.jpg
| | |

Balluff: Powerful Technology for Full Flexibility

Outstanding performance, low costs, flexible topology and easy handling: these are the advantages of the industrial Ethernet technology, EtherCAT. EtherCAT provides full flexibility: a free topology selection, the possibility of connecting and disconnecting devices and segments during operation, and the performance redundancy of the ring topology. EtherCAT is suitable for both centralized and decentralized architectures, supports Master/Slave, Master/Master, and Slave/Slave communication.

 

 

 

PBUS-25-Dold-UG6946StandstillMonitor-400.jpg
| | | |

DOLD: Safe Sensorless Standstill Monitoring

The safe sensorless standstill monitor UG 6946 from the SAFEMASTER S series detects the standstill of 3-phase and 1-phase motors independent of the direction of rotation. This means sensors such as encoders or proximity switches are not required. Access to the danger zone of a system is only possible by the enabling signal of the standstill monitor after the drive has been switched off and run down.

 

 

 

PBUS-25-TE-RaychemRSTI-400.jpg
| | |

Raychem RSTI-VS Separable Connector With Voltage Sensor

TE Connectivity has launched its Raychem smart RSTI-VS separable connector with voltage sensor, which can be used for grid monitoring and advanced earth fault and short circuit detection in IEC markets. Together with grid monitoring devices such as Kries’ IKI-50, distribution network operators can deploy condition monitoring, advanced fault detection and failure prediction in their networks.

 

 

 

PBUS-25-Weidmuller-NewColorOffering-400.jpg
| | |

Weidmuller WPD – New Color Offering

In expanding their commitment to providing standard duty connections, Weidmuller was recently proud to announce the addition of a new color-coded Power Distribution Block series to their already impressive selection of IP 20 feed-through terminals. These DIN rail/direct mountable blocks are intended for distributing main power sources for low voltage (600V AC/DC, 30-310A) applications, utilizing large wire sizes, and of course, maintaining finger-safe connections.

 

 

 

PBUS-25-Excelitas-dfineInspectionLens-400.jpg
| | |

Excelitas Technologies Introduces New LINOS d.fine HR Area Scan Module

Excelitas Technologies Corp. recently announced the LINOS d.fine HR Area Scan Module, which enables area scan applications for the company’s d.fine HR 2.4/128 3.33x High Resolution Inspection Lens. The combination of d.fine HR Lens and new Area Scan Module features a large image circle up to 82 mm and a high resolution up to 300 Lp/mm in a spectral distribution of 400 nm – 750 nm.

 

 

 

PBUS-25-Phoenix-SUNCLIX-400.jpg
| | | | |

Phoenix Contact: New Connectors for Photovoltaics

New connectors as well as cable-based string fuses extend the SUNCLIX product series for photovoltaic systems from Phoenix Contact. The device connectors are particularly suitable for cabling inverters and string combiner boxes. The fast screw connection saves you time and money during installation. A patented Unlock system enables smaller actual dimensions as well as convenient release without the need for a special tool.

 

 

 

PBUS-25-Bel-Cat6aCableSplicer-400.jpg
| | | |

Quick Ethernet Connections With the Cat 6a Cable Splicer

Stewart Connector, a Bel group company, recently announced the release of their tool-less Cat 6a Cable Splicer. Stewart Connector’s cable splicer is a time-saving solution for Ethernet connections that require field terminations. The cable splicer is designed to create easy connections between patch cables and installation cables for consolidation point applications or for end-to-end links.

 

 

 

PBUS-25-Siemens-SIRIUSACTIDKey-400.jpg
| | | |

Siemens: Control the Speed Directly on the Machine With SIRIUS ACT ID Key-Operated Switches

The easiest way to control the speed directly on the machine is to use an analog potentiometer. However, wearing gloves in dusty or humid environments, for example, makes operation more difficult. Therefore, the use of the robust SIRIUS ACT ID key-operated switch as a digital potentiometer is particularly suitable under these environmental conditions. This alternative with freely programmable IO-Link electronic module enables precise and fine-grained speed adjustment due to its tactile detent positions.

 

 

 

PBUS-25-Rittal-DataCentreCooling-400.jpg
| | |

Equipment Cooling for Data Centres & Plants: Why Your HVAC SYSTEM is a Poor Climate Control Unit

Data Centre and Plant Managers working in small and mid-sized businesses often find themselves searching their buildings for unused space to house the company’s IT and other enclosures. Mailrooms, empty offices, janitors’ closets…all have been repurposed into data closets holding one to a few racks. This approach may be the right choice in terms of square footage needed, but when it comes to proper climate conditions for sensitive IT equipment, it could not be more wrong.